• 12336 Emerson Dr, Brighton, MI 48116

Tacky Booth Coating 10-HT

A water based, clear tacky coating designed to remain tacky for a long period of time at temperatures up to 180°F

buy-now-blue-300x73

SKU: TBC-10-HT Category:

Product Description

Tacky Booth Coating 10-HT is a water-based, VOC-free, moderate temperature resistant, transparent masking material that forms a slightly tacky, shiny coating.

Tacky Booth Coating 10-HT is used as a water removable, temporary protective coating for spray booth windows, steel walls, and plastic hoses where overspray accumulation must be readily removed. This clear coating is designed to maximize the trapping of dust, dirt, and other airborne debris, while not altering the appearance the original substrate on which it was applied. A corrosion inhibitor in the compound prevents the rusting of steel. Tacky Booth Coating 10-HT forms a non-clouding flexible film which remains tacky for extended periods of time at temperatures up to 180 °F. In addition to paint spray booths, this material can be used in flash off zones and oven vestibules. For dry booths, please refer to our peelable coatings at www.strippablecoating.com.
water based, clear tacky booth coating, scrapable booth coating, high temperature booth coating, paint booth maintenance

TYPICAL PROPERTIES: Water based High Temperature clear tacky booth coating, scrapable booth coating, paint booth maintenance

Appearance: Thick, clear liquid
Odor: Mild ammonia odor
pH: 7.5 – 8.5
Flash Point: None
Specific Gravity: 1.02 – 1.03
VOC: 0.1 lbs/gal (EPA Method 24)

RECOMMENDED APPLICATION:
Tacky Booth Coating 10-HT is used as received, no dilution is needed. Recommended application is with airless spray equipment, however, air atomizing spray equipment, brush or roller application may be used.
Tacky Booth Coating 10-HT can be applied with airless spray equipment. A 30:1 ratio airless spray unit will provide good results.

CAUTION:
Airless equipment can be extremely hazardous. It is recommended that all precautionary information regarding the operation of an airless gun be read, understood, and followed.

SURFACE PREPARATION:

APPLICATION:

Tacky Booth Coating 10-HT should be applied with the air on in the booth to speed drying time. Tacky Booth Coating 10-HT should be sprayed in a uniform film of 10-mils to 15-mils wet thickness. This film will be damp, but non-smearing in 40 to 50 minutes. It will be dry to the touch in 60 minutes. With booth air off, a longer drying time will be needed.

REMOVAL:
Tacky Booth Coating 10-HT is readily removed with cold or hot water.

STORAGE:
Tacky Booth Coating 10-HT must be protected from freezing. If product should become frozen, warm to ambient temperature and mix thoroughly before using.

PRODUCT ADVANTAGES:
Water based
Nonflammable
Remains tacky for extended periods of time up to 180°F
Produces a clear, transparent film when dry
Low VOC

Note: The above information and recommendations concerning this product are based upon our laboratory tests and field use experience with this or similar products. However, since conditions of actual use are beyond our control, any recommendations or suggestions are made without warranty, express or implied. Manufacturer’s and seller’s sole obligation shall be to replace that portion of the product shown to be defective. Neither shall be liable for any loss, damage, or injury, direct or consequential, arising out of the use of this product. The information presented herein is our interpretation of certain test results and field experience to date. This information is not to be taken as warranty or representation for which we assume legal responsibility, nor as permission or recommendation to practice any patented invention without a license. It is offered solely for your consideration, investigation and verification.