• 12336 Emerson Dr, Brighton, MI 48116

Tacky Booth Coating 2329

A clear, water based, tacky, temporary booth coating that provides an excellent barrier for both water based and solvent based paints.

buy-now-blue

SKU: TBC-2329 Category:

Product Description

Tacky Booth Coating 2329 is a water-based transparent masking that forms a clear coating.

Tacky Booth Coating 2329 is used as a water removable, temporary protective coating for spray booth windows, steel walls, and plastic hoses where overspray accumulation must be readily removed. This clear coatings is designed to maximize the trapping of dust, dirt, and other airborne debris, while not altering the appearance of the original substrate on which it was applied. The composition of the masking inhibits the rusting of steel. Tacky Booth Coating 2329 forms a non-clouding flexible film. For dry booths, please refer to our peelable coatings at www.strippablecoating.com.

TYPICAL PROPERTIES: water based transparent masking , clear tacky booth coating
Appearance: Clear, viscous, odorless liquid
Viscosity: 10,000-15,000 cps
Specific Gravity: 1.0-1.1
Flash Point: None
VOC: 0.7-0.9 lbs/gal
pH: 8.5-9.5

RECOMMENDED APPLICATION:
Tacky Booth Coating 2329 can be applied by brush, spray or roller. It is used as received, no dilution is needed.
Recommended application is with airless spray equipment, however, air atomizing equipment, brush or roller application may be use . A 30:1 ratio airless spray unit with a 0.035” fluid orifice in the spray gun will provide good results.

CAUTION:
Airless equipment can be extremely hazardous. It is recommended that all precautionary information regarding the operation of an airless gun be read, understood, and followed.

SURFACE PREPARATION:
The surface to be coated should be clean and relatively dry for best adhesion of the coating.

APPLICATION:
Tacky Booth Coating 2329 should be applied with the air on in the booth to speed drying time. The material should be sprayed in a uniform film of 10-mils to 15-mils wet thickness. This film will be damp but non-smearing in 30 to 40 minutes. It will be dry but tacky to the touch in 60 minutes. Drying time may vary depending on film thickness, humidity and air flow.

REMOVAL:
Tacky Booth Coating 2329 is readily removed with cold or hot water.

STORAGE:
Tacky Booth Coating 2329 must be protected from freezing. If product should become frozen, warm to ambient temperature and mix thoroughly before using.

PRODUCT ADVANTAGES:
Water based
Water rinsable
Long lasting tack
Easily applied

Note: The above information and recommendations concerning this product are based upon our laboratory tests and field use experience with this or similar products. However, since conditions of actual use are beyond our control, any recommendations or suggestions are made without warranty, express or implied. Manufacturer’s and seller’s sole obligation shall be to replace that portion of the product shown to be defective. Neither shall be liable for any loss, damage, or injury, direct or consequential, arising out of the use of this product. The information presented herein is our interpretation of certain test results and field experience to date. This information is not to be taken as warranty or representation for which we assume legal responsibility, nor as permission or recommendation to practice any patented invention without a license. It is offered solely for your consideration, investigation and verification.