• 12336 Emerson Dr, Brighton, MI 48116

Tacky Booth Coating 2769

Imparts a lustrous white surface to booth walls and floors while remaining wet and tacky to attack airborne dust and dirt. It can be removed with a water rinse or scraping

buy-now-blue-300x73

SKU: BC-2769 Category:

Product Description

Tacky Booth Coating 2769 is a very tacky, white water-based paint spray booth wall masking designed to be removed by scraping or cold water spray. This product is used to protect booth walls and center track conveyor covers from paint overspray. It substantially reduces the amount of time necessary to remove paint overspray. It also reduces the amount of paint strippers that may be used in booth cleaning operations.

Tacky Booth Coating 2769 is bright white and light reflective to maximize booth illumination. The masking remains very tacky and moist, making it especially suited for modular paint booths and robotic painting operations. It is readily removed with low to moderate pressure, water spray or manual scraping.

Tacky Booth Coating 2769 is designed for water spray booths. For dry booths, please refer to our peelable coatings at www.strippablecoating.com.

TYPICAL PROPERTIES:

Appearance: White, viscous liquid
Viscosity: 20,000-30,000 cps
Specific Gravity: 1.16 – 1.22
Flash Point: None to boiling
VOC: 2.0 – 4.0 lbs/gal
pH: 7.5 – 8.5

RECOMMENDED APPLICATION:
Tacky Booth Coating 2769 can be applied by brush, spray or roller. It is used as received, no dilution is needed.
Tacky Booth Coating 2769 can be applied with airless spray equipment. When applying material over a large area, a 30:1 ratio airless spray unit with a 0.035” fluid orifice in the spray gun will provide good results.

CAUTION:
Airless equipment can be extremely hazardous. It is recommended that all precautionary information regarding the operation of an airless gun be read, understood, and followed.

SURFACE PREPARATION:
The surface to be coated should be clean and relatively dry for best adhesion of the coating.

APPLICATION:
Tacky Booth Coating 2769 should be sprayed in a uniform film of 10-mils to 15-mils wet thickness.

REMOVAL:
Tacky Booth Coating 2769 is readily removed with cold or hot water at low to moderate spray pressure or by manual scraping.

STORAGE:
Tacky Booth Coating 2769 must be protected from freezing.

PRODUCT ADVANTAGES:
Water base
Scrapable
Low VOC
Excellent tack
User friendly

Note: The above information and recommendations concerning this product are based upon our laboratory tests and field use experience with this or similar products. However, since conditions of actual use are beyond our control, any recommendations or suggestions are made without warranty, express or implied. Manufacturer’s and seller’s sole obligation shall be to replace that portion of the product shown to be defective. Neither shall be liable for any loss, damage, or injury, direct or consequential, arising out of the use of this product. The information presented herein is our interpretation of certain test results and field experience to date. This information is not to be taken as warranty or representation for which we assume legal responsibility, nor as permission or recommendation to practice any patented invention without a license. It is offered solely for your consideration, investigation and verification.